|
| |
TM 9-2320-364-20-2
2-1007
Allow engine to cool before performing
troubleshooting maintenance. If necessary
use insulated pads and gloves. Hot engine
components will burn and cause injury to
personnel.
Remove all jewelry such as rings, dog tags,
bracelets, etc. If jewelry or tools contact
positive electrical circuits, a direct short
may result. Damage to equipment, injury or
death to personnel may occur.
(1) Set multimeter select switch to
volts dc.
(2) Connect positive (+) multimeter lead
to vehicle harness connector MC18,
terminal A3.
(3) Connect negative (–) multimeter lead
to a known good ground.
(4) Turn ON ENGINE switch
(TM 9-2320-364-10).
(5) Are there 4 to 6 vdc present
between wire 916 at vehicle harness
connector MC18, terminal A3 and a
known good ground?
(a) If less than 4 vdc are present,
turn OFF ENGINE switch and
repair wire 916 (see schematic
Fig 2-1) or notify DS Maintenance.
(b) If 4 to 6 vdc are present, turn OFF
ENGINE switch and go to Step 5
of this Fault.
VOLTAGE TEST
|
