|
| |
TM 9-2320-364-20-2
2-821
(1) Disconnect transmission connector
MC19 from transmission bulkhead
connector.
(2) Connect breakout harness
transmission end connector to
transmission bulkhead connector.
(3) Set multimeter select switch to ohms.
(4) Is there continuity between wires 101
and 122 at transmission breakout
harness connector, terminals
E and H?
(a) If there is no continuity, fault is in
transmission. Notify DS
Maintenance.
(b) If there is continuity, oil level
sensor switch is OK.
CONTINUITY TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
|
