|
| |
TM 9-2320-364-20-2
2-1249
(1) Remove three screws and headlight
retaining ring.
(2) Remove headlight lamp.
(3) Disconnect wires 17, 18 and 91 at
electrical connectors.
(4) Set multimeter select switch to ohms.
(5) Is there continuity across headlight
lamp measured between connectors
on wires 17 and 91?
(a) If there is no continuity, replace
headlight lamp (Para 7-45).
(b) If there is continuity, headlight
lamp is OK.
CONTINUITY TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
(1) Set multimeter select switch to volts
dc.
(2) Connect positive (+) multimeter
lead to wire 1017.
(3) Connect negative (–) multimeter
lead to a known good ground.
(4) Turn ON ENGINE switch
(TM 9-2320-364-10).
(5) Turn on headlight switch.
(a)
If 10 to 14 vdc are not present,
perform Steps (6) through (10)
below and go to Step 8 of this
Fault.
(b)
If 10 to 14 vdc are present,
perform Steps (6) through (10)
below and go to Step 4 of this
Fault.
(6) Turn off headlight switch.
(7) Turn OFF ENGINE switch.
(8) Connect headlight wires 17, 18
and 91.
(9) Install headlight lamp.
(10) Install headlight retaining ring and
three screws.
VOLTAGE TEST
|
