|
| |
TM 9-2320-364-20-2
2-1261
(1) Set multimeter select switch to ohms.
(2) Remove screw, lockwasher, washer
and wire 1435. Discard lockwasher.
(3) Is there continuity between wire 1435
and a known good ground?
(a) If there is no continuity, repair wire
1435 (see schematic Fig 2-33).
(b) If there is continuity, wire 1435 is
OK.
(4) Install wire 1435, washer, lockwasher
and screw.
CONTINUITY TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
(1) Is there continuity between socket
ground and a known good ground?
(a) If there is no continuity, replace
composite light (Para 7-47).
(b) If there is continuity, taillight
ground is OK.
(2) Is there continuity between socket
power contact and wire 21?
(a) If there is no continuity, replace
composite light (Para 7-47).
(b) If there is continuity, taillight is OK.
(3) Connect taillight lead 21 to wire 1008.
(4) Install taillight lamp.
(5) Install preformed packing, composite
light cover and tighten six screws.
CONTINUITY TEST
|
