|
| |
TM 9-2320-364-20-2
2-1299
(1) Remove cable tie.
(2) Disconnect turn signal/flasher
connector MC7.
(3) Connect a jumperwire between
terminals C and F of
connector MC7.
(a) If left turn signal does not operate,
repair wire 1002 (see schematic
Fig 2-32) or notify DS
Maintenance.
(b) If left turn signal operates, replace
turn signal/flasher switch
(Para 7-35).
(4) Remove jumperwire.
(5) Connect turn signal/flasher connector
to harness connector MC7.
(6) Install cable tie.
VISUAL INSPECTION
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
(1) Turn on left turn signal
(TM 9-2320-364-10).
(a) If left front turn signal light does
not operate, fault not corrected.
Turn off left turn signal and notify
DS Maintenance.
(b) If left front turn signal operates,
fault has been corrected.
(2) Turn off left turn signal.
VERIFY REPAIR
|
