|
| |
TM 9-2320-364-20-2
2-1303
(1) Set multimeter select switch to
volts dc.
(2) Connect positive (+) multimeter lead
to socket power contact of turn signal
light socket.
(3) Connect negative (–) multimeter lead
to a known good ground.
(4) Turn on right turn signal
(TM 9-2320-364-10).
(a) If 2 to 10 vdc are not present,
turn off right turn signal and go to
Step 4 of this Fault.
(b) If 2 to 10 vdc are present,
turn off right turn signal and go to
Step 3 of this Fault.
VOLTAGE TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
NOTE
Voltage will pulsate between 2 to 10 vdc
during turn signal voltage test.
|
