|
| |
TM 9-2320-364-20-2
2-1309
(1) Remove cable tie.
(2) Disconnect turn signal/flasher
connector MC7.
(3) Connect a jumperwire between
terminals A and F of connector
MC7.
(a) If right turn signal does not
operate, repair wire 1001 (see
schematic Fig 2-31) or notify DS
Maintenance.
(b) If right turn signal operates,
replace turn signal/flasher switch
(Para 7-35).
(4) Remove jumperwire.
(5) Connect turn signal/flasher connector
to harness connector MC7.
(6) Install cable tie.
VISUAL INSPECTION
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
(1) Turn on right turn signal
(TM 9-2320-364-10).
(a) If right front turn signal does
not operate, fault not corrected.
Turn off right turn signal and
notify DS Maintenance.
(b) If right front turn signal operates,
fault has been corrected.
(2) Turn off right turn signal.
VERIFY REPAIR
|
