|
| |
TM 9-2320-364-20-2
2-1577
(1) Remove ten screws and sunshield
from instrument panel.
(2) Pull top of instrument panel towards
steering wheel.
(3) Remove LOW AIR lamp.
(4) Set multimeter select switch to ohms.
(5) Is continuity measured between lamp
terminals?
(a) If there is no continuity, replace
lamp (Para 7-24).
(b) If there is continuity, go to Step 2
of this Fault.
CONTINUITY TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits a direct short may result. Damage to equipment, injury or death to personnel may occur.
|
