|
| |
TM 9-2320-364-20-2
2-1595
(1) Set multimeter select switch to volts
dc.
(2) Connect positive (+) multimeter lead
to wire 1082 at FAN control switch
terminal B.
(3) Connect negative (–) multimeter lead
to a known good ground.
(4) Turn ON ENGINE switch
(TM 9-2320-364-10).
(a) If 22 to 28 vdc are not present,
perform Step (5) below and repair
or replace wire 1082 (see
schematic Fig 2-42).
(b) If 22 to 28 vdc are present,
wire 1082 is OK.
(5) Turn OFF ENGINE switch.
VOLTAGE TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
|
