|
| |
TM 9-2320-364-20-2
2-1601
(1) Remove fire extinguisher
(TM 9-2320-364-10).
(2) Remove 22 screws, lockwashers,
washers and cab engine access panel
from cab. Discard lockwashers.
(3) Inspect that both belts are installed
and are in good condition.
(a) If both belts are not installed or
are not in good condition, install
new belts (Para 7-4).
(b) If both belts are installed and are
in good condition, perform Step
(4) below.
(4) Install belt tension gage on each
belt. Belt tension gage must read
between 55 to 65 lbs (245-289 N).
(a) If belt tension gage does not
measure between 55 to 65 lbs
(245-289 N), adjust
alternator belts (Para 7-4).
(b) If belt tension gage does
measure between 55 to 65 lbs
(245-289 N), go to Step 2 of
this Fault.
VISUAL INSPECTION
|
