| |
TM 9-2320-364-20-2
2-861
(1) Connect DDR cable to DDL
connector MC13.
(2) Clear ATEC codes (Para 2-11).
(3) Start engine (TM 9-2320-364-10) and
observe CTL.
(a) If TRANS CHECK light comes on
for about five seconds then goes
off, fault has been corrected.
Perform Steps (4) and (5) below.
(b) If TRANS CHECK light comes on
and stays on after engine warms
up, perform Steps (4) and (5)
below and go to Fault Index
(Table 2-26).
(4) Turn OFF ENGINE switch.
(5) Disconnect DDR cable from DDL
connector MC13.
VERIFY REPAIR
|