| |
TM 9-2320-364-20-3
2-2885
(1) Remove LHS control assembly
(Para 7-40).
(2) Set multimeter select switch to
volts dc.
(3) Connect positive (+) multimeter lead
to wire 1755 on connector MC83,
terminal E.
(4) Connect negative () multimeter lead
to a known good ground.
(5) Turn ON ENGINE switch
(TM 9-2320-364-10).
(a) If 22 to 28 vdc are not present,
turn OFF ENGINE switch and
repair wire 1755 (see schematic
Fig 2-52) or notify DS
Maintenance. Install LHS control
assembly (Para 7-40).
(b) If 22 to 28 vdc are present,
wire 1755 is OK.
(6) Turn OFF ENGINE switch.
VOLTAGE TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment and injury or death to personnel may occur.
|