|
| |
TM 9-2320-364-20-3
2-2033
(1) Disconnect connector from transducer
on rear manifold.
(2) Set multimeter select switch to
volts dc.
(3) Connect positive (+) multimeter lead
to black wire terminal at transducer
connector.
(4) Connect negative (–) multimeter lead
to rear manifold ground braid.
(5) Turn ON ENGINE switch
(TM 9-2320-364-10).
(6) Push CTIS START button.
(a) If 4.7 to 5.2 vdc are not present,
turn OFF ENGINE switch and
replace rear manifold
(Para 13-9).
(b) If 4.7 to 5.2 vdc are present,
turn OFF ENGINE switch and
go to Step 5 of this Fault.
(7) Connect connector on transducer.
VOLTAGE TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positve electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
|
