|
| |
TM 9-2320-364-20-3
2-2239
(1) Set multimeter select switch to
volts dc.
(2) Connect positive (+) multimeter
lead to wire 1722 at LHS lamp
electrical connector terminal.
(3) Connect negative (–) multimeter
lead to a known good ground.
(4) Turn ON ENGINE switch
(TM 9-2320-364-10).
(5) Set hydraulic selector switch to
MAN HA position.
(a) If 22 to 28 vdc are not present,
perform Steps (6) through (9)
below and go to Step 3 of this
Fault.
(b) If 22 to 28 vdc are present,
perform Steps (6) through (9)
below and go to Step 11 of this
Fault.
(6) Set hydraulic selector switch to
OFF position.
(7) Turn OFF ENGINE switch.
(8) Install LHS lamp and socket in
instrument panel.
(9) Install instrument panel and sunshield
with ten screws.
VOLTAGE TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
1435 1722
INSTRUMENT PANEL
SCREW
SUNSHIELD
ENGINE SWITCH
HYDRAULIC
SELECTOR
SWITCH
STEERING WHEEL
SHOWN REMOVED
FOR CLARITY
ELECTRICAL
CONNECTOR
|
