|
| |
TM 9-2320-364-20-3
2-2261
Keep clear of equipment when equipment is being raised or lowered. Equipment may fall and cause
serious injury or death to personnel.
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
(1) Start engine (TM 9-2320-364-10).
(2) Raise LHS until middle frame is
approximately 3 ft (91 cm) above
the transit position.
(3) Turn OFF ENGINE switch.
(4) Turn ON ENGINE switch.
(5) Set multimeter select switch
to volts dc.
(6) Connect positive (+) multimeter
lead to wire 1725 at LHS NO
TRANS lamp electrical connector
terminal.
(7) Connect negative (–) multimeter
lead to a known good ground.
(a) If there are not 22 to 28 vdc
present, perform Steps (8)
and (9) below and go to Step 3
of this Fault.
(b) If there are 22 to 28 vdc
present, perform Steps (8) and
(9) below and go to Step 11
of this Fault.
(8) Set hydraulic selector switch to
OFF position.
(9) Turn OFF ENGINE switch.
VOLTAGE TEST
|
