|
| |
TM 9-2320-364-20-3
2-2271
(1) Remove LHS control assy
(Para 7-40).
(2) Connect harness connector MC81,
terminal M to ground using jumperwire.
(3) Is there continuity between harness
connector MC88, terminal B and a
known good ground?
(a) If there is no continuity, repair wire
1471 (see schematic Fig 2-52)
and perform Steps (4) through (6)
below or notify DS Maintenance.
(b) If there is continuity, wire 1471
is OK.
(4) Remove jumperwire from harness
connector MC81 terminal M and
ground.
(5) Connect harness connector MC88 to
proximity switch connector.
(6) Install LHS control assy
(Para 7-40).
CONTINUITY TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
|
