| |
TM 9-2320-364-20-3
2-2281
(1) Start engine (TM 9-2320-364-10).
(2) While observing LHS NO TRANS
light, raise LHS in AUTO mode using
joystick until middle frame is
approximately 3 ft (91 cm) above
transit position.
(a) If LHS NO TRANS light does not
operate, fault not corrected.
Perform Steps (3) and (4) below
and notify DS Maintenance.
(b) If LHS NO TRANS light does
operate, fault has been corrected.
(3) Set hydraulic selector switch to OFF
position.
(4) Turn OFF ENGINE switch.
VERIFY REPAIR
Keep clear of equipment when equipment is being raised or lowered. Equipment may fall and cause
serious injury or death to personnel.
|