| |
TM 9-2320-364-20-3
2-2311
(1) Remove harness connector from
transit valve.
(2) Set multimeter select switch
to volts dc.
(3) Connect positive (+) multimeter lead
at connector, terminal 2.
(4) Connect negative () multimeter lead
to a known good ground.
(5) Turn ON ENGINE switch
(TM 9-2320-364-10).
(6) Push in middle frame safe lowering
button.
(a) If there are not 22 to 28 vdc
present, perform Steps (7) through
(9) below and go to Step 3 of
this Fault.
(b) If there are 22 to 28 vdc present,
perform Steps (7) through (9) below
and go to Step 8 of this Fault.
(7) Turn OFF ENGINE switch.
(8) Install harness connector on transit
valve.
(9) Tighten connector screw and coat
head of screw with adhesive.
VOLTAGE TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment and injury or death to personnel may occur.
(1) Loosen four screws and open
main junction box.
(2) Connect positive (+) multimeter lead
at main junction box terminal 9.
(3) Connect negative () multimeter lead
to a known good ground.
(4) Turn ON ENGINE switch
(TM 9-2320-364-10).
(a) If there are not 22 to 28 vdc
present, perform Step (5) below
and go to Step 1 of Fault 4 of this
Chapter.
(b) If there are 22 to 28 vdc present,
perform Step (5) below.
(5) Turn OFF ENGINE switch.
VOLTAGE TEST
Do not allow the LHS control box assembly
cover to hang from console by the wire
connections to the control box assembly.
Failure to comply will damage the wire
connections.
Adhesive, solvents, and sealing compounds
can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To
avoid injury or death, keep away from open
fire and use in a well-ventilated area. If
adhesive, solvent, or sealing compound gets
on skin or clothing, wash immediately with
soap and water.
|