| |
TM 9-2320-364-20-3
2-2371
(1) Disconnect harness connector MC93
from hydraulic selector switch
connector.
(2) Set multimeter select switch to ohms.
(3) Is there continuity between harness
connector MC83, terminal A and
harness connector MC93, terminal D?
(a) If there is no continuity, repair wire
1482 (see schematic Fig 2-52).
(b) If there is continuity, wire 1482 is
OK.
(4) Install LHS control assembly
(Para 7-40).
CONTINUITY TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
|