|
| |
TM 9-2320-364-20-3
2-2409
(1) Disconnect harness connector MC93
from hydraulic selector switch
connector.
(2) Set multimeter select switch to ohms.
(3) Is there continuity between harness
connector MC93, terminal B and
harness connector MC83, terminal D?
(a) If there is no continuity, repair wire
1480 (see schematic Fig 2-52) or
notify DS Maintenance.
(b) If there is continuity, wire 1480 is
OK.
(4) Install LHS control assembly
(Para 7-40).
CONTINUITY TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
|
