|
| |
TM 9-2320-364-20-3
2-2489
86
85
30
87
RELAY R35
TERMINAL 87
STEERING WHEEL
SHOWN REMOVED
FOR CLARITY
ENGINE SWITCH
HYDRAULIC
SELECTOR
SWITCH
(1) Set multimeter select switch to volts DC.
(2) Connect positive (+) mulitmeter lead to
relay R35 at terminal 87.
(3) Connect negative (–) multimeter lead
to a known good ground.
(4) Turn ON ENGINE switch
(TM 9-2320-364-10).
(a) If 22 to 28 vdc are not present,
replace relay R35 (Para 21-15) and
perform Step (5) below.
(b) If 22 to 28 vdc are present,
perform Step (5) below and go to
Step 9 of this Fault.
(5) Turn OFF ENGINE switch.
VOLTAGE TEST
Remove all jewelry such as rings, dog tags,
bracelets, etc. If jewelry or tools contact positive
electrical circuits, a direct short may result.
Damage to equipment, injury or death to
personnel may occur.
|
