|
| |
TM 9-2320-364-20-3
2-1941
(1) Remove ten screws and sunshield
from instrument panel.
(2) Pull top of instrument panel
toward steering wheel.
(3) Disconnect rear manifold harness
connector MC110 from back of
CTIS controller.
(4) Disconnect front manifold harness
connector MC111 from back of
CTIS controller.
(5) Connect harness connector MC111
into CTIS controller where
connector MC110 was
disconnected.
(6) Connect harness connector MC110
into CTIS controller where
connector MC111 was
disconnected.
(7) Start engine (TM 9-2320-364-10).
(8) Set CTIS controller to CROSS
COUNTRY.
(9) As assistant pushes CTIS controller
START button, observe tires.
(a) If tires on Axles No. 1 and No.
2 do not deflate, replace CTIS
controller (Para 13-7).
(b) If tires on Axles No. 1 and No.
2 deflate, CTIS controller is OK.
(10) Turn OFF ENGINE switch.
(11) Disconnect and connect connectors
MC110 and MC111 to correct CTIS
controller connectors.
(12) Start engine.
(13) Set CTIS controller to HIGHWAY
and allow tire pressure to build.
(14) Turn OFF ENGINE switch.
CTIS CONTROLLER TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positve electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
|
