| |
TM 9-2320-364-20-3
2-1955
(1) Remove ten screws and sunshield
from instrument panel.
(2) Pull top of instrument panel toward
steering wheel.
(3) Disconnect rear manifold harness
connector MC110 from back of
CTIS controller.
(4) Disconnect front manifold harness
connector MC111 from back of
CTIS controller.
(5) Connect harness connector MC111
into CTIS controller where
connector MC110 was
disconnected.
(6) Connect harness connector MC110
into CTIS controller where
connector MC111 was
disconnected.
(7) Start engine (TM 9-2320-364-10).
(8) Set CTIS controller to CROSS
COUNTRY.
(9) As assistant pushes CTIS controller
START button, observe tires.
(a)
If tires on Axles No. 3 through
No. 5 do not deflate, turn
OFF ENGINE switch and
replace CTIS controller
(Para 13-7).
(b)
If tires on Axles No. 3 through
No. 5 deflate, CTIS controller
is OK.
(10) Turn OFF ENGINE switch.
(11) Disconnect and connect connector
MC110 to correct CTIS controller
connector.
(12) Start engine.
(13) Set CTIS controller to HIGHWAY
and allow pressure to build.
(14) Turn OFF ENGINE switch.
CTIS CONTROLLER TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits a direct short may result. Damage to equipment, injury or death to personnel may occur.
|