| |
TM 9-2320-364-20-3
2-2701
(1) Is there continuity between outrigger
mast shutdown valve harness
connector, terminal 2 and a known
good ground?
(a) If there is no continuity, repair
connector black wire (see
schematic Fig 2-58) or notify DS
Maintenance.
(b) If there is continuity, perform
Steps (2) and (3) below and go to
Step 24 of this Fault.
(2) Install harness connector on outrigger/
mast shutdown valve solenoid and
tighten screw.
(3) Install crane main junction box cover
with six clips and screws.
CONTINUITY TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
|