| |
TM 9-2320-364-20-3
2-2715
(1) Set multimeter select switch to ohms.
(2) Is there continuity between crane
junction box, terminal 3 and main
hydraulic pressure valve harness
connector, terminal 1?
(a) If there is no continuity, repair
connector white wire (see
schematic Fig 2-58) or notify DS
Maintenance.
(b) If there is continuity, install cover
with six clips and screws and go
to Step 23 of this Fault.
CONTINUITY TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
|