|
| |
TM 9-2320-364-20-3
2-2745
(1) Set multimeter select switch to ohms.
(2) Is there continuity between system
hydraulic pressure valve connector,
terminal 1 and crane junction box,
terminal 8?
(a) If there is no continuity, repair
connector white wire (see
schematic Fig 2-58) or notify DS
Maintenance.
(b) If there is continuity, perform
Step (3) below and go to
Step 14 of this Fault.
(3) Connect system hydraulic pressure
harness connector and tighten screw.
CONTINUITY TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
|
