|
| |
TM 9-2320-364-20-3
2-2801
(1) Set multimeter select switch to
ohms.
(2) Is there continuity on black wire
between HIGH IDLE switch and
power switch?
(a) If there is no continuity, repair
black wire (see schematic
Fig 2-58).
(b) If there is continuity, go to
Step 15 of this Fault.
CONTINUITY TEST
Remove all jewelry such as rings, dog tags, bracelets, etc. If jewelry or tools contact positive electrical
circuits, a direct short may result. Damage to equipment, injury or death to personnel may occur.
Leave all wires attached to switches.
NOTE
|
