|
| |
TM 9-2320-364-20-4
12-162
12-34. LOAD SENSING VALVE ADJUSTMENT (CONT).
(8)
Remove nut (5), lockwasher (6) and link assembly (7) from axle bracket (8). Discard lockwasher.
(9)
Loosen low pressure limit capscrew (9) and adjust the load sensing valve (10) until the pressure gage
assembly connected to air tank No. 5 (2) reads 31 psi (214 kPa) 2 psi (14 kPa).
(10)
Rotate low pressure stop (11) until tab on the stop touches the control shaft cross pin (12). Tighten
capscrew (10) to 72 to 84 lb-in (8 to 9 N.m).
(11)
Loosen two jam nuts (13) and adjust link assembly (7) to align with hole in axle bracket (8).
(12)
Tighten two jam nuts (13).
(13)
Install link assembly (7) on axle bracket (8) with lockwasher (6) and nut (5).
|
