|
| |
TM 9-2320-364-20-4
2-3227
Ensure transfer case is cool before proceeding. Failure to comply may result in injury to personnel.
(d)
When transfer case is cool enough to touch, seal breather with moisture proof tape.
(e)
Coat all exposed, unpainted surfaces with preservative grease such as petrolatum (Item 63,
Appendix C), Class 2 or equivalent.
(f)
If additional storage time is required, repeat Step (b) at yearly intervals.
(8)
Main hydraulic system extended storage.
To avoid over filling, drain oil before installing or damage to equipment may result.
(a)
Drain amount of oil from main hydraulic reservoir that is equal to the quantity of additive being
added (Para 14-2).
(b)
Add 8.5 qts (8L) VCI-326 (Item 95, Appendix C), vapor corrosion inhibitor or equivalent to main
hydraulic reservoir.
(c)
Operate all ancillary equipment:
LHS - two complete cycles.
Crane - (if equipped) cycle each crane function two cycles.
Self Recovery Winch - winch out approximately six feet of cable, then winch in. Repeat cycle twice.
(d)
If additional storage time is required, repeat Steps (a) and (b) at yearly intervals.
(9)
Steering hydraulic system extended storage.
To avoid over filling, drain oil before installing additive or damage to equipment may result.
(a)
Drain amount of oil from steering hydraulic reservoir that is equal to the quantity of additive being
added (Para 20-11).
(b)
Add 1.6 pts (0.75L) VCI-326 (Item 95, Appendix C), vapor corrosion inhibitor or equivalent to
steering hydraulic reservoir.
(c)
Operate steering system to mix additive. Turn steering wheel to full right turn and then full left turn.
Repeat this cycle three times.
(d)
If additional storage time is required, repeat Steps (a) and (b) at yearly intervals.
(10)
Steering reduction gear box (2:21 to 1) extended storage.
None Required.
|
