|
| |
TM 9-2320-364-20-4
3-8
3-4. LEFT ROCKER COVER AND GASKET REPLACEMENT (CONT).
NOTE
Fill plug is located on left rocker
cover only.
(20)
Remove filler cap plug (31) from rocker
cover (22).
(21)
Remove chain hook (32) from filler cap
plug (31).
(22)
Remove and discard three screws (33) from
strainer (34).
(23)
Remove strainer (34), filler cap tube (35)
and seal (36) from rocker cover (22).
Discard seal.
b.
Cleaning/Inspection.
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face
shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when
using solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees
C) and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may
result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention.
(1)
Clean all parts with drycleaning solvent.
Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use only with
effective chip guarding and personal protective equipment (goggles/shield, gloves, etc.) or
injury to personnel may result.
(2)
Dry all parts with compressed air.
(3)
Blow out groove in rocker cover with compressed air.
(4)
Inspect all parts for holes, cracks, chips or stripped threads. Replace damaged parts.
|
