|
| |
TM 9-2320-364-20-4
4-13
c.
Cleaning/Inspection
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face
shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when using
solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees C) and
Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may result in
injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention.
Do not clean air filter or pre-cleaner filter in weather cap assembly with dry cleaning
solvent. Filters may become plugged and damage to equipment may result.
(1)
Clean all metal parts with drycleaning solvent.
Compressed air used for cleaning purposes will not exceed 30 psi (207 kPa). Use only with
effective chip guarding and personal protective equipment (goggles/shield, gloves, etc). Failure
to comply may result in injury or death to personnel.
(2)
Dry all metal parts with compressed air.
(3)
Clean rubber parts with clean, dry cloth.
(4)
Inspect all parts for cracks, stripped threads and other signs of wear.
(5)
Replace all damaged parts.
d.
Assembly
NOTE
Perform Step (1) if studs were
removed.
(1)
Install studs (17) and retaining rings (16) on
air cleaner housing (2).
(2)
Install weather cap assembly (9) on air
cleaner housing (2) with six screws (15),
lockwashers (14) and nuts (13).
9
15
14
2
17
16
13
|
