|
| |
TM 9-2320-364-20-4
4-36
4-8. MAIN FUEL TANK AND BRACKETS REPLACEMENT (CONT).
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound gets
on skin or clothing, wash
immediately with soap and water.
NOTE
Perform Steps (3) and (4) if
adhesive tape was removed.
(3)
Apply spray adhesive to two fuel tank
brackets (12) and allow to dry.
(4)
Install rubber adhesive tape (38) by
removing protective backing and installing
on two fuel tank brackets (12).
(5)
Install two fuel tank brackets (12) and
brackets (30) with 12 screws (36) and
locknuts (35) on frame (37). Tighten
locknuts to 210 lb-ft (285 N.m).
(6)
Install two clamps (34) on brackets (30) with
screws (33) and locknut (32).
NOTE
Perform Step (7) if strap liners
were removed.
(7)
Install strap liners (31) on each fuel tank
strap (28).
NOTE
Fuel tank straps are properly
installed when three threads are
showing through end of nut.
(8)
Install two fuel tank straps (28) on
brackets (30) with two nuts (29).
|
