|
| |
TM 9-2320-364-20-4
4-66
4-10. FUEL SHUTOFF VALVE REPLACEMENT (CONT).
NOTE
Note position of float arm when
removing.
(4)
Remove fuel level sending unit (5) from top
of fuel tank (9).
(5)
Remove and discard gasket (10) from top of
fuel tank (9).
b.
Installation.
NOTE
Use non-hardening sealant on
outer edge of fuel level sending
unit tank access hole only.
(1)
Using non-hardening sealant, install
gasket (10) on top of fuel tank (9).
NOTE
Install fuel sending unit as noted
in removal.
(2)
Install fuel level sending unit (5) on fuel
tank. (9).
(3)
Install four screws (8) on fuel level sending
unit (5) and tank (9). Tighten screws to
36 lb-in (4 N.m).
(4)
Install wire 1435 (7) and screw (6) on fuel
level sending unit (5) and fuel tank (9).
Tighten screw to 36 lb-in (4 N.m).
(5)
Install wire 1318 (4), washer (3),
lockwasher (2) and locknut (1) on top of fuel
level sending unit (5). Tighten nut to
36 lb-in (4 N.m).
c.
Follow-On Maintenance:
Connect batteries, (Para 7-87).
Check fuel gage operation, (TM 9-2320-364-10).
Install tread platform assembly, (Para 15-9)
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
