|
| |
TM 9-2320-364-20-4
6-50
6-7. THERMOSTAT REPLACEMENT (CONT).
(18)
Install thermostat (14) in left thermostat
housing (6).
Adhesive causes immediate
bonding on contact with eyes,
skin, or clothing and also gives
off harmful vapors. Wear
protective goggles and use in
well-ventilated area. If adhesive
gets in eyes, try to keep eyes
open; flush eyes with water for
15 minutes and get immediate
medical attention.
(19)
Apply adhesive sealant sparingly to
gasket (12).
(20)
Position gasket (12) on left thermostat
housing (6).
(21)
Install left thermostat housing (6) on engine
block (13) with two lockwashers (11) and
screws (10). Tighten screws finger tight.
(22)
Install clip (9), lockwasher (8) and screw (7)
in left thermostat housing (6). Tighten
screw finger tight.
(23)
Tighten three screws (7) and (10) on left
thermostat housing (6) 23 to 26 lb-ft (31 to
35 N.m).
(24)
Install hump hose (5) and clamp (4) on left
thermostat housing (6). Tighten clamp to
100 lb-in (11 N.m).
(25)
Position hose (3) from top crossover
tube (2) on left thermostat housing (6) and
tighten two clamps (1) to 40 lb-in (4 N.m).
|
