|
| |
TM 9-2320-364-20-4
7-17
(2)
Remove locknut (5) from screw (6) on
bottom alternator mounting bracket (7).
Discard locknut.
(3)
Position locknut (5) on screw (6).
(4)
Loosen nuts (8) on alternator support
arm (9).
(5)
Remove screw (10), lockwasher (11) and
washer (12) from eye rod end (13) and
alternator (14). Discard lockwasher.
(6)
Remove outer nut (8), lockwasher (16) and
eye rod end (13), from alternator support
arm (9). Discard locknuts.
(7)
Remove two alternator belts (18) from
alternator (14) and engine pulley (19).
b.
Installation.
NOTE
When installing arctic alternator
belts, kit includes three belts;
only two are required.
(1)
Install two alternator belts (18) on alternator
(14) and engine pulley (19).
(2)
Position lockwasher (16) and outer nut (8)
on alternator support arm (9).
(3)
Install washer (12), lockwasher (11) and
screw (10) on alternator (14) and eye rod
end (13). Tighten screw (10) to 50 to 55
lb-ft (68 to 75 N.m).
(4)
Tighten nut (8) on inside of eye rod end (13)
until light tension is on belts (18).
|
