|
| |
TM 9-2320-364-20-4
7-54
7-12. STARTER MOTOR REPLACEMENT (CONT).
(6)
Remove two of three screws (25) and
lockwashers (26) from starter mounting
bracket (27). Discard lockwashers.
Starter weighs 73 lbs (33 kg).
Attach suitable lifting device
prior to removal to prevent
possible injury to personnel.
(7)
Install lifting device and raise lifting device
to support weight of starter (14).
(8)
With the aid of an assistant, remove
remaining screw (25) and lockwasher (26)
from starter mounting bracket (27). Discard
lockwasher.
NOTE
Starter is lowered between frame and tires.
(9)
Remove starter (14) from flywheel housing (28).
(10)
Remove and discard gasket (29) from starter (14) and flywheel housing (28).
(11)
Remove lifting device from starter (14).
b.
Installation.
(1)
Install gasket (29) on starter (14).
Starter weighs 73 lbs (33 kg). Attach suitable lifting device prior to installation to prevent
possible injury to personnel.
NOTE
Install cable ties as required.
(2)
Install lifting device and raise lifting device to support weight of starter (14).
NOTE
Starter is lifted between frame and tires.
(3)
With the aid of an assistant, position starter (14) in flywheel housing (28).
(4)
With the aid of an assistant, support starter (14) and position one of three lockwashers (26) and
screws (25) in starter mounting bracket (27).
(5)
Remove lifting device from starter (14).
(6)
Install remaining two lockwashers (26) and screws (25) in starter mounting bracket (27). Tighten all
three screws 137 to 147 lb-ft (186 to 199 N.m).
|
