|
| |
TM 9-2320-364-20-4
7-56
7-12. STARTER MOTOR REPLACEMENT (CONT).
(12)
Install wires 1139 (5), 1055 (4) and 1139
(3), lockwasher (2) and nut (1) on starter
solenoid (6). Tighten nut to 30 lb-ft
(41 N.m).
Adhesive causes immediate
bonding on contact with eyes,
skin, or clothing and also gives
off harmful vapors. Wear
protective goggles and use in
well-ventilated area. If adhesive
gets in eyes, try to keep eyes
open; flush eyes with water for
15 minutes and get immediate
medical attention.
(13)
Apply electrical sealant to terminals (30),
(31) and (32).
c.
Follow-On Maintenance:
Connect batteries, (Para 7-87).
Check starter operation, (TM 9-2320-364-10).
Install left front noise panel, (Para 17-27).
Install left side noise panel, (Para 17-28).
Install left front and rear skirt, (Para 17-34).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
31
32
30
|
