|
| |
TM 9-2320-364-20-4
7-58
7-13. INSTRUMENT PANEL REPLACEMENT (CONT).
NOTE
Tag and mark electrical connectors before removal.
(3)
Loosen screws (7) and (8) and remove MC4 (9) and MC8 (10) connectors from wiring harness
connectors (11) and (12).
NOTE
Connectors are disconnected by gently prying up on lock tabs and pulling connector apart.
(4)
Remove MC34 (13) and MC112 (14) connectors from wiring harness connectors (15) and (16).
(5)
Remove MC35 (17), MC105 (18),
MC110 (19) and MC111 (20) connectors
from connectors (21), (22), (23) and (24) on
rear of CTIS controller (25).
(6)
Remove locknut (26) and three ground
straps (27) from stud (28). Discard locknut.
(7)
Remove instrument panel (3) from
dash (5).
b.
Installation.
NOTE
Install cable ties as required.
(1)
Position instrument panel (3) on dash (5).
(2)
Install three ground straps (27) and
locknut (26) on stud (28).
(3)
Apply corrosion preventive compound to
stud (28).
(4)
Install MC35 (17), MC105 (18), MC110 (19)
and MC111 (20) connectors on
connectors (21), (22), (23) and (24) on rear
of CTIS controller (25).
|
