| |
TM 9-2320-364-20-4
7-76
7-16. CIRCUIT BREAKER REPLACEMENT (CONT).
b.
Installation.
NOTE
Where bus bar is used, bus bar
must be installed on rear of all
circuit breakers that are to be
attached to bus bar.
(1)
Position circuit breaker CB4 (5) in ECB (9).
(2)
Position nut (8) on face of circuit breaker
CB4 (5). Tighten nut to 16 to 24 lb-in
(1.3 to 2 N.m).
(3)
Connect wire 1292/1040 (6) to terminal (7)
on rear of circuit breaker CB4 (5).
(4)
Install bus bar (4) and wire 1176 (3)
lockwasher (2) and screw (1) on rear of
circuit breaker CB4 (5).
c.
Follow-On Maintenance:
Install Electronic Control Box (ECB) cover, (Para 17-22).
Connect batteries, (Para 7-87).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|