|
| |
TM 9-2320-364-20-4
7-106
7-31. HYDRAULIC SELECTOR SWITCH REPLACEMENT (CONT).
(3)
Install wires 1724 (11), 1487 (12), 1483 (13),
1481 (14), 1480 (15), 1486 (16), 1482 (17),
1484 (18) and 1485 (19) in hydraulic selector
switch (8) with nine screws (10).
(4)
Install two jumperwires (20) in hydraulic
selector switch (8) with two screws (10).
(5)
Install hydraulic selector switch (8),
hydraulic selector switch front mounting
plate (5) and four screws (7) on heater
control left side panel (9).
NOTE
Hydraulic selector switch face
plate snaps in place.
(6)
Install hydraulic selector switch face
plate (6) on hydraulic selector switch front
mounting plate (5).
(7)
Install knob (4) on hydraulic selector switch
front mounting plate (5) with screw (3).
(8)
Connect MC94 connector (2).
(9)
Connect MC93 connector (1).
c.
Follow-On Maintenance:
Install heater compartment cover, (Para 17-4).
Connect batteries, (Para 7-87).
Start engine, (TM 9-2320-364-10).
Check hydraulic selector switch operation, (TM 9-2320-364-10).
Shut OFF engine, (TM 9-2320-364-10).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
