|
| |
TM 9-2320-364-20-4
7-153
(5)
Measure out 4 in. (10 cm) from center of each cross (6) in four directions to make an 8 in. (20 cm)
square (7).
(6)
Turn engine switch (8) to ON position.
(7)
Turn head light switch (9) on and set dimmer button (10) on low beam.
(8)
Note location where head light beams strike vertical surface. If head light beams strike within squares,
head light aim is correct. Go to end of task. If head light beams strike outside squares, perform
adjustment.
4 IN.
(10 CM)
4 IN.
(10 CM)
|
