|
| |
TM 9-2320-364-20-4
7-177
b.
Disassembly.
(1)
Remove wire guard (1) from reverse
light (6).
(2)
Lubricate edge of lamp (3) with soap solution
and remove lamp from reverse light (6).
(3)
Loosen two screws (4) and remove
connectors (5) from rear of lamp (3) and
remove lamp.
c.
Assembly.
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in
well-ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing,wash
immediately with soap and water.
(1)
Apply corrosion preventive compound on
two connectors (5).
(2)
Install two connectors (5) and screws (4) on
rear of lamp (3).
(3)
Install lamp (3) in reverse light (6).
(4)
Install wire guard (1) on reverse light (6).
d.
Installation.
(1)
Position washer (7) and reverse light (6)
on rear crossmember (8).
(2)
Install lockwasher (4) and nut (3) on
reverse light mounting screw (5).
Tighten nut to 35 lb-ft (47 N.m).
(3)
Apply corrosion preventive compound on MC77 connector (1).
(4)
Connect MC77 connector (1) to wire harness (2).
e.
Follow-On Maintenance:
Connect batteries, (Para 7-87).
Check operation of reverse light, (TM 9-2320-364-10).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
