|
| |
TM 9-2320-364-20-4
7-205
Use caution while removing
connectors from ECM. The
ECM has plastic retainers that
may break if connectors are not
properly removed.
NOTE
Perform Steps (7) through
(15) only if removing the
electronic control module.
Tag and mark wiring
harness connectors before
removal.
Connectors are removed by
gently prying up on locking
tab with connector tool and
pulling connector out.
(7)
Using connector tool, remove three wiring
harness connectors (18) from ECM (14).
(8)
Loosen two screws (19) and remove wiring
harness connectors (20) from ECM (14).
|
