|
| |
TM 9-2320-364-20-4
7-212
7-57.
DDEC III ENGINE COLD PLATE/ELECTRONIC CONTROL MODULE
(ECM) REPLACEMENT (CONT).
Use caution while removing
connectors from ECM. The
ECM has plastic retainers that
may break if connectors are not
properly removed.
NOTE
Tag and mark wiring
harness connectors before
removal.
Connectors are removed by
gently prying up on locking
tab with connector tool and
pulling connector out.
(5)
Remove 5-way power wiring harness
connector MC17 (11) from left side of ECM
(9).
(6)
Loosen screw (12) and remove vehicle
wiring harness connector MC18 (13) from
left side of ECM (9).
(7)
Remove screw (14), lockwasher (15) and
washer (16) from ECM bracket (17).
Discard lockwasher.
(8)
Remove screw (18), lockwasher (19),
washer (20) and turbo boost sensor bracket
(21) from ECM bracket (17). Discard
lockwasher.
13
12
9
11
17
14
15
16
18
20
19
21
|
