|
| |
TM 9-2320-364-20-4
8-9/(8-10 blank)
b.
Cleaning/Inspection
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles, face
shield, and gloves; use only in a well-ventilated area; avoid contact with skin, eyes, and
clothes, and do not breathe vapors. Keep away from heat or flame. Never smoke when
using solvent. The flashpoint for Type II Drycleaning Solvent is 140 degrees F (60 degrees
C) and Type III Drycleaning Solvent is 200 degrees F (93 degrees C). Failure to do so may
result in injury or death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts skin or clothes, flush with cold water. If solvent contacts
eyes, immediately flush eyes with water and get immediate medical attention.
(1)
Clean transmission breather and reducer with drycleaning solvent and air dry.
(2)
Check for cracks, dents and/or stripped threads.
(3)
Replace damaged parts.
c.
Installation.
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,
and are harmful to skin and clothing. To avoid injury or death, keep away from open fire
and use in a well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
(1)
Apply sealing compound to threads of
reducer (2).
(2)
Install reducer (2) in transmission (3).
(3)
Apply sealing compound to threads of
transmission breather (1).
(4)
Install transmisison breather (1) in
transmission (3).
d.
Follow-On Maintenance:
Install right side noise panel, (Para 17-26).
Remove where chocks, (TM 9-2320-364-10).
END OF TASK
1
2
3
TRANSMISSION
SHOWN REMOVED
FOR CLARITY
|
