|
| |
TM 9-2320-364-20-4
10-2
Materials/Parts
Grease (Item 42, Appendix C)
Sealing Compound (Item 77, Appendix C)
Solvent, Drycleaning (Item 87, Appendix C)
This task covers:
a. Removal
c. Cleaning/Inspection
e. Installation
b. Disassembly
d. Assembly
f. Follow-On Maintenance
INITIAL SETUP
Personnel Required
Two
Equipment Condition
Engine OFF, (TM 9-2320-364-10)
Wheels chocked, (TM 9-2320-364-10)
LHS fully extended, (for transmission to transfer
case driveshaft), (TM 9-2320-364-10)
Tools and Special Tools
Tool Kit, General Mechanic’s: Automotive
(Item 74, Appendix G)
Bar, Crow (Item 4, Appendix G)
Compressor Unit, Air (Item 11, Appendix G)
Gloves, Chemical Oil Protective
(Item 28, Appendix G)
Goggles, Industrial (Item 30, Appendix G)
Gun, Airblow (Item 31, Appendix G)
Wrench, Torque (0 to 175 lb-ft [0 to 24 N.m])
(Item 95, Appendix G)
10-2. DRIVESHAFT AND UNIVERSAL JOINT REPAIR.
Materials/Parts - Continued
Journal and Bearing Kit (Axles No. 1 and No. 5
Driveshaft) (Item 82, Appendix F)
Journal and Bearing Kit (Axles No. 2 and No. 4
Driveshaft) (Item 84, Appendix F)
Journal and Bearing Kit (Axle No. 3 Driveshaft)
(Item 83, Appendix F)
a.
Removal.
Driveshafts can weigh up to 100 lbs (45 kg), obtain aid from an assistant to prevent possible
injury to personnel.
NOTE
All driveshafts are removed, disassembled, cleaned, assembled and installed the same way.
Driveshaft between transmission and transfer is shown.
A crow bar may be necessary to hold yokes from turning.
|
