|
| |
TM 9-2320-364-20-4
11-7
This task covers:
a. Inspection
b. Follow-On Maintenance
INITIAL SETUP
Personnel Required
Two
Equipment Condition
Engine OFF, (TM 9-2320-364-10)
Wheels chocked, (TM 9-2320-364-10)
Tools and Special Tools
Bar, Wrecking (Item 5, Appendix G)
Jack, Hydraulic, Hand (Item 40, Appendix G)
Jackstand (Item 42, Appendix G)
Wooden Block (Appendix D)
11-4. AXLES NO. 1, 2 AND 5 PIVOT AND SPINDLE INSPECTION.
a.
Inspection.
Use jackstands to support axle
weight. Failure to comply may
result in injury to personnel.
(1)
Position jack under axle (1) and raise axle
until tire (2) is just off ground.
(2)
Position jackstand under axle (1) and lower
axle onto jackstand.
(3)
Position wrecking bar between tire (2) and
ground.
NOTE
If wheel play is noticed, notify
DS Maintenance.
(4)
With the aid of an assistant, watch for play at
hub gear socket (3) and ball (4) while prying
up on tire (2).
(5)
Remove wrecking bar.
(6)
Raise axle (1) and remove jackstand.
(7)
Lower axle (1) and remove jack.
b.
Follow-On Maintenance:
Remove wheel chocks, (TM 9-2320-364-10)
END OF TASK
|
