|
| |
TM 9-2320-364-20-5
14-29
Materials/Parts
Cable Ties (2) (Item 25, Appendix C)
Cross and Bearing (Item 28, Appendix F)
Fitting, Lubrication (Item 42, Appendix F)
Locknut (Item 133, Appendix F)
Locknut (Item 143, Appendix F)
This task covers:
a. Removal
b. Installation
c. Follow-On Maintenance
INITIAL SETUP
Equipment Condition
Engine OFF, (TM 9-2320-364-10)
Wheels chocked, (TM 9-2320-364-10)
Tools and Special Tools
Tool Kit, General Mechanic’s: Automotive
(Item 74, Appendix G)
Bar, Crow (Item 4, Appendix G)
Compressor Unit, Air (Item 11, Appendix G)
Gloves, Chemical Oil Protective
(Item 28, Appendix G)
Goggles, Industrial (Item 30, Appendix G)
Gun, Airblow (Item 31, Appendix G)
Wrench, Torque (0 to 175 lb-ft [0 to 237 N.m])
(Item 95, Appendix G)
14-10. AXLE NO. 5 STEERING SHAFT REPAIR.
a.
Removal.
NOTE
Note location and position of steering shaft yoke on steering gear prior to removal.
Do not move truck during replacement. If wheels are moved, notify Direct Support to
perform steering timing procedure.
(1)
Remove locknut (1), screw (2) and steering shaft (3) from splined end of steering gear (4).
Discard locknut.
|
