|
| |
TM 9-2320-364-20-5
14-36
Materials/Parts
Solvent, Drycleaning (Item 87, Appendix C)
Locknut (Item 127, Appendix F)
Pin, Cotter (2) (Item 277, Appendix F)
This task covers:
a. Removal
c. Cleaning/Inspection
e. Installation
b. Disassembly
d. Assembly
f. Follow-On Maintenance
INITIAL SETUP
Personnel Required
Two
Equipment Condition
Engine OFF, (TM 9-2320-364-10)
Wheels chocked, (TM 9-2320-364-10)
Wheel/tire removed, (TM 9-2320-364-10)
Tools and Special Tools
Tool Kit, General Mechanic’s: Automotive
(Item 74, Appendix G)
Compressor Unit, Air (Item 11, Appendix G)
Gloves, Chemical Oil Protective
(Item 28, Appendix G)
Goggles, Industrial (Item 30, Appendix G)
Gun, Air Blow (Item 31, Appendix G)
Jack Kit, Hydraulic, Hand (Item 41, Appendix G)
Tape Measure (Item 66, Appendix G)
Wrench, Combination 1-5/16 in.
(Item 81, Appendix G)
Wrench, Torque (0 to 175 [0 to 237 N.m])
(Item 95, Appendix G)
14-11. AXLE NO. 1, 2 AND 5 TIE-ROD REPAIR.
a.
Removal.
NOTE
Note location of tie-rod ends prior to removal.
All tie rods are removed the same. Axle No. 2 shown.
(1)
Remove cotter pin (1) and loosen castle nut (2) until it is flush with bottom of stud on tie-rod end (3).
Discard cotter pins.
|
