|
| |
TM 9-2320-364-20-5
17-87
b.
Installation.
Adhesives, solvents, and sealing
compounds can burn easily, can
give off harmful vapors, and are
harmful to skin and clothing. To
avoid injury or death, keep away
from open fire and use in well-
ventilated area. If adhesive,
solvent, or sealing compound
gets on skin or clothing, wash
immediately with soap and
water.
NOTE
Perform Steps (1) through (4)
if insulation or rubber pads
were removed.
Ensure that adhesive is
applied to side of insulation
that contacts rear panel.
(1)
Coat insulation (7) with adhesive.
(2)
Position insulation (7) on rear noise panel
(6).
(3)
Press insulation (7) evenly over entire
surface.
(4)
Coat one side of rubber pads (8) with
adhesive.
(5)
Install rubber pads (8) on rear noise panel
(6).
(6)
Install eight screws (5), rear panel
rubber (4), three retaining strips (2) and (3)
and eight locknuts (1) on rear noise panel
(6).
c.
Follow-On Maintenance:
Install rear noise panel, (Para 17-29).
Remove wheel chocks, (TM 9-2320-364-10).
END OF TASK
|
